All products ship same day from our warehouse in Walnut, CA if ordered within the shipping cutoff times
PI Manufacturing TAA compliant products meet the U.S. Government's Trade Agreements Act (TAA), which fosters fair and open international trade.
TAA compliant products can only be acquired from products made in the United States or in an approved country.
10/100/1000Mbps Gigabit PoE Extender Switch, 60W Input (Requires POE-INJ-1000G-4 or POE-INJ-1000G-5)
Ethernet and PoE connections both restrict cable distances to 100 meters between network ports. The POE-REP-1000-4 is the perfect solution to overcome this distance limit by using Cat5e or Cat6 Ethernet cable. The Gigabit PoE extender can extend PoE devices (such as IP cameras, VoIP telephones, wireless access points) up to 100 meters from one another. By connecting the PoE extender for every extra 100 meters of cable, both Ethernet and PoE can be extended to 200 meters, depending on PoE power required and power source.
The PoE extender does not require any additional power supply, while the connected PoE device is fed by a single PoE switch. The PoE extender offers four Ethernet out ports, which are configured automatically for link speed, duplex, crossover, and with full-rate network throughout. The total PoE power can reach up to 60W or 95W, a PoE injector (POE-INJ-1000G-4 or POE-INJ-1000G-5) will be needed to provide IEEE802.3at 4 Pairs (60W or 95W) power.
Maximum Distances for Power Sources
Multiple PoE Extenders can be connected every 100 meters to obtain greater distances. The actual figures depend on the operating conditions. The range is over 24AWG or heavier Cat5e or Cat6 cable except where specified.
Diagram 1: General Connection
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
(California law requires this warning to be provided to California customers)
|No. of channels||1 (PoE IN) into 4 (PoE OUT)|
|Pass through data rates||10/100/1000Mbps half/full duplex|
|Power over Ethernet input||Pin assignment and polarity:|
Both 1/2 (-), 3/6 (+) and 7/8 (-), 4/5 (+)
|Power over Ethernet output||Pin assignment and polarity: 1/2 (-), 3/6 (+)|
Output power: up to 12W for 4 PSE or 25W for 2 PSE
|Indicators||LED indicators located on the RJ45 connector|
Power indicator: PoE enabled
Powered success: Power
Network indicator: Link/Act
|Connectors||Shielded RJ45, EIA 568A and 568B|
|Dimensions||119mm x 85mm x 28mm|
|Operating Temperature||-10°C ~ 45°C|
|Storage Temperature||-30°C ~ 70°C|
|Storage Humidity||0% ~ 95% (non-condensing)|
|Operating Humidity||0% ~ 90% (non-condensing)|
|PoE Standards||IEEE 802.3af (15.4W)|
IEEE 802.3at (30W)
IEEE802.3at 4 Pairs (60W)
See Us in Action