LCD-JT-2517
Assembly Instructions
|
|
(1) Set the large base and the pole in the position shown. |
|
(2) Use two screws to secure the base to the pole. |
|
|
(3) Mount the square monitor plate to the pole, using 4 screws and 4 nuts. |
|
(4) Mount the long rectangular arm bracket to the square plate. Secure the bracket with 4 screws and washers from the front. Place 4 nuts onto the screws from the back. |
|
|
(6) Now we will assemble
the arms. |
|
(7) To assemble the right arm, start with the two pieces shown. Put the inner arm in the outer arm. Place the metal cylinder inside the arm, in the area indicated by the arrow. |
|
|
(8) Place the screw (with the 4-sided square shape) into the cylinder. |
|
(9) Turn the arm over. Fasten the turn-handle over the screw. |
|
|
(10) Fasten the long screw along with a washer (as shown) into the hole near the turn handle. |
|
(11) Turn the arm and fasten the nut onto the screw. Assemble the left arm in a similar manner. Mount the arms to the LCD monitor. Place them onto the main bracket. |
|
|
(12) Once you are satisfied
with the position of the monitor, slide the long bar under the arms (as
pictured) until secure. |
|
|
