GPOWER-S3 Camera & Keyboard Tutorial - Setup and Use
	Snap in the connector into the unit as shown. Connect 12V power to the camera.
	We will set up PTZ control for the camera. For ID, we will set #26 as the ID. Dip switches 2,4,5 will be in the down position; others in the up position. For protocol, set dip switches 9,10 in the down position. (This will use the Eyeview protocol.)
	Connect the PTZ wires from the camera to the green terminal block on the keyboard. The leftmost will be the black wire; the second-to-left will be the white wire. For keyboard protocol, set switches 1 and 2 to the down position.
	Connect power to the keyboard DC12V port. It should show "Camera ID: 26" If it does not show, you can set the camera to 26 by pressing "Cam"->"26"->"Enter".
	"TELE" and "WIDE" will zoom in and out. The arrow keys will pan and tilt the camera. Speed be changed by pressing 1 to 8 before the arrrow key. "NEAR" and "FAR" will change the focus between near and far objects. To set a recallable camera position, Adjust the camera to the desired position Press "SET" Type a number between 1-128 Press "ENTER" To activate a preset position, Press "PRESET" Type a number between 1-128 Press "ENTER"

Question and answer